Transfer tape for ATG 700 transparent, double-sided strong adhesive in 12mm x 33m

Transfer tape for ATG 700 transparent, double-sided strong adhesive in 12mm x 33m

Colour: transparent
Dimension: 12mm x 33m

Transfer tape with excellent adhesive behaviour on paper and cardboard
super strong adhesive
is used, for example, to attach product samples, posters, photos etc.
not removable

Properties:
Adhesive: acrylate
Thickness: 50µm (=0.05mm)
Width: 12mm
Length per roll: 33m
Liner: paper cover
Adhesive strength: 9N / cm

Processing and storage instructions Surface condition Surfaces must be dry and free of dust, oil, oxides, release agents and other contaminants. Surface cleaning The following cleaning agents, for example, can be used to remove dust, oil, release agents and other contaminants: Isopropanol/water 50/50 Heptane or ethanol Acetone or MEK Suitable other cleaning agents that leave no residue and do not attack the substrate Translated with DeepL.com (free version)


Technical properties 

Type of cover Paper 
Thickness 290 µm 
Adhesive Natural rubber, thermosetting 
Backing material Acrylic-coated fabric 
Punchability Yes 
Abrasion resistance very good 
Temperature resistance (30 min.) 180 °C 
Elongation at break 7.5 % 
Tear strength 105 N/cm 
Adhesive strength on steel 4.6 N/cm
Labelling Yes 
Straight tear-off edge very good 
Hand tearability very good 
Liner release force 0.3 N/cm 
Mesh 145 count per square inch 
Temperature resistance (removability from aluminium after 30 min exposure) 180 °C 
Water resistant good 
Easy to remove Yes




 

Processing and storage information
Surface condition
Surfaces must be dry, free from dust, oil, oxides, release agents and other contaminants.

Surface cleaning
The following cleaning agents, for example, can be used to remove dust, oil, separating agents and other impurities:

• Isopropanol/water 50/50
• Heptane or ethanol
• Acetone or MEK
• Suitable other cleaning agents that do not leave any residues and do not attack the substrate.

Temperature
The most favourable processing temperature (object and ambient temperature) is between +15°C and +25°C.

Pressure
The strength of the bond is directly dependent on the contact that the adhesive has with the surfaces to be bonded. A short, high pressure (e.g. with a squeegee, pressure roller or pressure device, etc.) ensures good surface contact. The type and amount of pressure depends on the material (thin- or thick-walled, etc.) and the geometry of the components. Rule of thumb: approx. 20 N/cm².

Storage
The rolls should be stored in their packaging protected from light at a temperature between +15°C and +25°C and a relative humidity of 50%.

Note
The technical information is given to the best of our knowledge, but is not binding. The information only has the character of a general recommendation. The suitability of the product for the desired purpose must be ensured by own tests under the original conditions. A legal assurance of certain properties cannot be derived from our information.