PVC surface protection film white 50mm x 66m
PVC surface protection film is ideal for protecting sensitive surfaces from mechanical or chemical influences. For interior and exterior use to protect the following surfaces: Lacquers and plastics with a low gloss level, stainless steel and windows, matt, textured surfaces.
- adhesive on one side
- 50mm x 66m
- surfaces to be protected must be dry, free from dust, oil, release agents and other contaminants
- thickness: 0,053mm
- colour: white
- Adhesive: natural catschuk
Processing and storage instructions
Surface condition
Surfaces must be dry, free from dust, oil, oxides, separating agents and other impurities.
Surface cleaning
The following cleaning agents, for example, can be used to remove dust, oil, separating agents and other impurities:
Isopropanol/water 50/50
Heptane or ethanol
Acetone or MEK
Suitable other cleaning agents that do not leave any residues and do not attack the substrate.
Temperature
The most favourable processing temperature (object and ambient temperature) is between +15°C and +25°C.
Pressure
The strength of the bond is directly dependent on the contact that the adhesive has with the surfaces to be bonded. A short, high pressure (e.g. with a squeegee, pressure roller or pressure device, etc.) ensures good surface contact. The type and amount of pressure depends on the material (thin- or thick-walled, etc.) and the geometry of the components. Rule of thumb: approx. 20 N/cm².
Storage
The rolls should be stored in their packaging protected from light at a temperature between +15°C and +25°C and a relative humidity of 50%.
Note
The technical information is given to the best of our knowledge, but is not binding. The information only has the character of a general recommendation. The suitability of the product for the desired purpose must be ensured by own tests under the original conditions. A legal assurance of certain properties cannot be derived from our information.
