Hard paper cores cardboard cores brown 1000mm x 3mm

Hard paper cores cardboard cores brown 1000mm x 3mm

Colour: brown
Wall thickness: 3
Length: 1000mm
Inner diameter: 76 mm
Outer diameter: 82 mm

This rigid paper core is used as a winding core for films, textiles, paper and other materials. Thanks to its stability and bending strength, it can also be used as a spacer, protective packaging or protective sleeve in cardboard boxes for pressure-sensitive goods.
High stability and flexural strength
spirally wound
as a winding core for films, textiles, paper, adhesive tape, fabrics, non-wovens, etc.
as a spacer / protective packaging / protective sleeve in cardboard boxes for pressure-sensitive goods


Possible applications
Tubes, posters, calendars, maps, etc. 
Winding cores, shelf sleeves, display tubes
Construction tubes, protective sleeves
Spacers, cardboard sleeves, cardboard tubes, craft items, etc.

Note: The technical information is given to the best of our knowledge, but is not binding. The information is only a general recommendation. Suitability of the product for the desired purpose must be ensured by carrying out your own tests under the original conditions. A legal guarantee of certain properties cannot be derived from our information.

Processing and storage instructions
Surface condition
Surfaces must be dry, free from dust, oil, oxides, release agents and other contaminants.

Surface cleaning
The following cleaning agents, for example, can be used to remove dust, oil, release agents and other impurities:
- Isopropanol/water 50/50
- Heptane or ethanol
- Acetone or MEK
- Suitable other cleaning agents that do not leave any residues and do not attack the substrate.

Temperature
The most favourable processing temperature (object and ambient temperature) is between +15°C and +25°C.

Pressure
The strength of the bond is directly dependent on the contact that the adhesive has with the surfaces to be bonded. A short, high pressure (e.g. with a squeegee, pressure roller or pressure device, etc.) ensures good surface contact. The type and amount of pressure depends on the material (thin- or thick-walled, etc.) and the geometry of the components. Rule of thumb: approx. 20 N/cm².

Storage
The rolls should be stored in their packaging protected from light at a temperature between +15°C and +25°C and a relative humidity of 50%.

Note
The technical information is given to the best of our knowledge, but is not binding. The information only has the character of a general recommendation. The suitability of the product for the desired purpose must be ensured by own tests under the original conditions. A legal assurance of certain properties cannot be derived from our information.