Tesa 4289 Rim Tape yellow, no Notubes Yellow Tape Strapping Tape
The high-quality Tesa Rim Tape 4289 is a universally applicable and extremely tear-resistant strapping tape based on a mop film with a one-sided natural rubber adhesive compound, which gives the tape a high adhesive strength. The rim tape is an essential part of the wheel set, because the strapping tape prevents the tyre tube from pressing against the holes in the rims and tearing open.
- Very high tear strength with low elongation
- Thick and abrasion resistant film
- Good resistance to heat and cold
- High adhesive strength for bonding to a wide variety of surfaces
- Non-staining
- Very friendly handling
- Different widths for optimum coverage of the rim bed
Product properties
- Carrier: MOPP
- Adhesive: natural rubber
- length: 66 m
- Thickness: 0.145 mm
- Adhesive strength (on steel): 5 N / cm
- Tearing force: 420 N / cm
- Elongation at break: 35
- Colour: yellow
Possible applications
Processing and storage information
Surface condition
The surfaces must be dry, free of dust, oil, oxides, release agents and other contaminants.
Surface cleaning
The following cleaning agents, for example, can be used to remove dust, oil, release agents and other impurities:
- Isopropanol/water 50/50
- Heptane or ethanol
- Acetone or MEK
- Suitable other cleaning agents that do not leave any residues and do not attack the substrate.
Temperature
The most favourable processing temperature (object and ambient temperature) is between +15°C and +25°C.
Pressure
The strength of the bond is directly dependent on the contact that the adhesive has with the surfaces to be bonded. A short, high pressure (e.g. with a squeegee, pressure roller or pressure device, etc.) ensures good surface contact. The type and amount of pressure depends on the material (thin- or thick-walled, etc.) and the geometry of the components. Rule of thumb: approx. 20 N/cm².
Storage
The rolls should be stored in their packaging protected from light at a temperature between +15°C and +25°C and a relative humidity of 50%.
Note
The technical information is given to the best of our knowledge, but is not binding. The information only has the character of a general recommendation. The suitability of the product for the desired purpose must be ensured by own tests under the original conditions. A legal assurance of certain properties cannot be derived from our information.
