Crepe tape for paint masking
Dimension: 30mm x 50m
The masking tape was specially developed for car paint jobs in the automotive industry with subsequent oven drying up to 110 degrees. This masking tape consists of an impregnated, tear-resistant, flat creped paper backing, which is coated on 1 side with a natural rubber adhesive. It is a universally applicable masking, packaging and assembly tape for industry and trade, which is also used for bundling and strapping as well as for making paper and cardboard webs endless.
- Tearable by hand
- Balanced adhesive strength
- Easily removable
- Not suitable for drying chambers!
- Particularly thin
- Water-repellent due to impregnation
- Wet-sanding resistant
Product properties
- Carrier: crepe paper
- Adhesive: natural rubber (heat resistant)
- Width: 30 mm
- Length: 50 m
- Thickness: 0.14 mm
- Adhesive strength: 5.75 N / 2.5 cm
- Tearing force: 85 N / 2.5 cm
- Elongation at break: > 9 % (+/1 10%)
- Temperature resistance: up to 110°C (1 hour)
- Colour: chamois
Application and possible uses
- For simple work without special requirements
- Covering
- Protect
- Hold
- Fixing
Processing and storage instructions
Surface condition
Surfaces must be dry, free from dust, oil, oxides, release agents and other contaminants.
Surface cleaning
The following cleaning agents, for example, can be used to remove dust, oil, separating agents and other impurities:
- Isopropanol/water 50/50
- Heptane or ethanol
- Acetone or MEK
- Suitable other cleaning agents that do not leave any residues and do not attack the substrate.
Temperature
The most favourable processing temperature (object and ambient temperature) is between +15°C and +25°C.
Pressure
The strength of the bond is directly dependent on the contact that the adhesive has with the surfaces to be bonded. A short, high pressure (e.g. with a squeegee, pressure roller or pressure device, etc.) ensures good surface contact. The type and amount of pressure depends on the material (thin- or thick-walled, etc.) and the geometry of the components. Rule of thumb: approx. 20 N/cm².
Storage
The rolls should be stored in their packaging protected from light at a temperature between +15°C and +25°C and a relative humidity of 50%.
Note
The technical information is given to the best of our knowledge, but is not binding. The information only has the character of a general recommendation. The suitability of the product for the desired purpose must be ensured by own tests under the original conditions. A legal assurance of certain properties cannot be derived from our information.
