3M Paint protection film PU 8591E 15cm x 16,5m

3M Paint protection film PU 8591E Stone chip protection
Colour: transparent

The 3M 8591 high performance protective film has been specially developed for the protection of painted surfaces and is used in many interior and exterior applications where additional protection against mechanical or chemical impact is required. The paint protection film protects against scratches, stone chips and UV light.

Article features:
Has been specially developed for the protection of painted automotive surfaces
protects against mechanical influences
preserves the appearance in the long term
adapts to complex contours
due to good adhesive properties, films can also be applied around corners and edges
Glossy surface
transparent
very high material thickness
resistant to scratching and high temperatures
width. 15 cm
length: 16,5 metre

properties:
Excellent reduction of noise
protection against stone chipping, chipping in cold weather and shattering
very good adaptability to complex shapes, corners and edges
reliable adhesion of the adhesive under environmental stresses such as temperature changes and humidity
Adhesive: clear acrylate
Paper backing

Article description:
Suitable for bumpers, bodywork, door edges etc.
Protection against chemical and mechanical attack
Protection against chipping in cold weather, shattering and stone chipping
Good adaptability to complex contours
High material thickness 0.350mm = 350 µm
Transparent glossy surface
Suitable for wet bonding

IMPORTANT CHANGE IN THE BACKING PAPER: With immediate effect, 3M as the manufacturer will only supply the PU8591 E protective film in all material widths with neutral i.e. white liner. The previously used backing paper with the small 3M logo will no longer be used. (As of September 2008) This can be confirmed in a letter from 3M, which we can send to you on request.

Processing and storage instructions
Surface condition:
Surfaces must be dry, free from dust, oil, oxides, release agents and other contaminants.

Surface cleaning:
The following cleaning agents, for example, can be used to remove dust, oil, separating agents and other impurities:
- Isopropanol/water 50/50
- Heptane or ethanol
- Acetone or MEK
- Suitable other cleaning agents that do not leave any residues and do not attack the substrate.

Note:
We provide the technical information to the best of our knowledge, but without obligation. The information only has the character of a general recommendation. A suitability of the product for the desired