3M Paint protection film PU 8592E Stone chip protection
Colour: transparent
- width. 10 cm (=100mm)
- length: 1m
The 3M 8591 high performance protective film has been specially developed for the protection of painted surfaces and is used in many interior and exterior applications where additional protection against mechanical or chemical impact is required. The paint protection film protects against scratches, stone chips and UV light.
Article features:
- Has been specially developed for the protection of painted automotive surfaces
- protects against mechanical influences
- preserves the appearance in the long term
- adapts to complex contours
- due to good adhesive properties, films can also be applied around corners and edges
- Glossy surface
- transparent
- very high material thickness
- resistant to scratching and high temperatures
properties:
- Excellent reduction of noise
- protection against stone chipping, chipping in cold weather and shattering
- very good adaptability to complex shapes, corners and edges
- reliable adhesion of the adhesive under environmental stresses such as temperature changes and humidity
- Adhesive: clear acrylate
- Paper backing
Article description:
- Suitable for bumpers, bodywork, door edges etc.
- Protection against chemical and mechanical attack
- Protection against chipping in cold weather, shattering and stone chipping
- Good adaptability to complex contours
- High material thickness 0.2032mm = 203,2 µm
- Transparent glossy surface
- Suitable for wet bonding
IMPORTANT CHANGE IN THE BACKING PAPER: With immediate effect, 3M as the manufacturer will only supply the PU8592 protective film in all material widths with neutral i.e. white liner. The previously used backing paper with the small 3M logo will no longer be used. (As of September 2008) This can be confirmed in a letter from 3M, which we can send to you on request.
Processing and storage instructions
Surface condition:
Surfaces must be dry, free from dust, oil, oxides, release agents and other contaminants.
Surface cleaning:
The following cleaning agents, for example, can be used to remove dust, oil, separating agents and other impurities:
- Isopropanol/water 50/50
- Heptane or ethanol
- Acetone or MEK
- Suitable other cleaning agents that do not leave any residues and do not attack the substrate.
Note:
We provide the technical information to the best of our knowledge, but without obligation. The information only has the character of a general recommendation. A suitability of the product for the desired
